4

Is this an IDE or something completely different. Could it be used to connect gotek?

CN13 CDTV Rev 2.2.1

Improve this question

1 Answer 1

Reset to default
6

That's CN13. The pins are documented here and have address and data lines as you would expect for memory, not the signals you would need for a floppy drive.

I would connect a Gotek to the DB-23 connector on the rear panel.

Improve this answer
2
  • Is there a way to connect it internally?
    – Bartek Malysz
    Commented Jul 28, 2020 at 21:37
  • 2
    @BartekMalysz Short of soldering a ribbon cable to the pins of the DB-23, I don't see a way. But the DB-23 is already DF0, so if the purpose is to boot from floppy, you don't need to do anything internally.
    – snips-n-snails
    Commented Jul 28, 2020 at 23:05

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .