8

I have an Amiga 1200 with an SD card and Classic WB installed. I have four drives DH0, DH1, DH2, DH3, when I start the machine with workbench it mounts all devices. If if start the machine using skip startup sequence then only DH0, DH1 and DH2 are mounted. How could I skip DH1 and DH2 from being auto mounted and how could I make DH3 be auto mounted?

Improve this question

1 Answer 1

Reset to default
7

Each partition on an Amiga hard drive has settings that determine whether it is bootable and whether it should be auto-mounted. It sounds like your DH3 partition is not set for auto-mounting, and the other 3 partitions are set for auto-mounting. Furthermore, you have a "Mount" command within your boot drive's S/Startup-Sequence that is causing DH3 to be mounted for a normal boot.

My recommendation would be to run HDToolBox from Workbench (probably in "Tools") to confirm the settings for auto-mounting on the 4 partitions. If you want, you can set only DH0 and DH3 to be auto-mount. Then, you could use Mount commands to mount DH1 and DH2 as needed.

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .