Questions tagged [cpu]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
75
votes
9answers
11k views

Why is the processor instruction called "move", not "copy"?

Many processors have an instruction called "move" (sometimes spelled MOV) which copies data from one location (the "source") to another (the "destination") in registers and/or memory. It does not do ...
9
votes
6answers
3k views

Is there any music source code for sound chips? [closed]

I’ll clarify what I mean. The sound chip (c64's SID, spectrum's Yamaha, etc.) is connected either to the input / output port, which will be reserved for the sound chip, or directly to the CPU data bus....
6
votes
2answers
288 views

Why was the maximum byte size of 8 bits on IBM 7030?

As far as I know, IBM 7030 used term byte. But this byte was just an imaginary term to make easier for our brain to work with bits. So it had nothing in common with a physical realization of the CPU. ...
13
votes
3answers
3k views

What was the first CPU with exposed pipeline?

Quoting from Programming for Performance exercise: early versions of the MIPS processor had an "exposed pipeline" (that is, the assembly language programmer needed to know the latencies of ...
13
votes
7answers
5k views

Does the Intel 8085 CPU use real memory addresses?

The Intel 8086 CPU uses memory segmentation, which means that when, for example, you write the value 123 to the memory address 1001, the memory address 1001 will actually get converted first into ...
34
votes
2answers
2k views

Can the two CPUs in a Commodore 128 run at the same time?

The Commodore 128 has two CPUs. One is some variant of the 6502, and the other is a Z80. One CPU is there for compatibility with the Commodore 64 and the other is there presumably to give basic ...
16
votes
1answer
2k views

How do accelerators and CPU cards work on the Apple II?

An Amiga 1200 exposes the entire CPU bus on the expansion port, so that an accelerator only needs to assert BR which causes the onboard CPU to stop all computation and electrically disconnect from the ...
13
votes
1answer
2k views

Intel processor transistor type evolution

The Intel 4004 used MOS (metal–oxide–semiconductor) transistors. What has been the transistor types used in Intel processors onwards from the 4004 to 8085 to the x86 family of instruction set ...
6
votes
1answer
370 views

Tannenbaum paper on constants in ISAs?

I see many references to a paper by Andrew Tanenbaum that demonstrated the vast majority of constants would fit into 13-bits, and I seem to recall it being in my university text on CPU design. However,...
3
votes
2answers
1k views

How exactly do all control signals in 6502 work?

I'm trying to make a 6502 replica in Logisim. I want to know what exactly each control signal in 6502, how the clock cycles work and additionally I would like to see an example of these control ...
15
votes
2answers
3k views

Why did some CPUs use two Read/Write lines, and others just one?

Many 8-bit processors, such as Motorola's 6800 and MOS Technology's 6502 make use of a single pin to indicate to the rest of the system whether the CPU wishes to read from or write to a memory ...
7
votes
5answers
672 views

Could the Intel 8086 CPU have many segments in memory of the same type?

The Intel 8086 CPU could address up to 1 MB of memory using segmentation, and this CPU have 4 segment registers, which are CS and SS and DS and ES. Each segment in memory can have a maximum size of ...
2
votes
4answers
568 views

Which part of a computer does the conversion between binary to hexadecimal? [closed]

I know most computer architecture store data in binary in drives/storage, but i'm unsure where in a computer (x86, etc) does the conversion/interpretation of binary (base2) to hexadecimal (base16) ...