Questions tagged [hardware]

Retro hardware generally: boards, extension cards, power supplies, peripherals. Use more specific tags as appropriate; use [case] instead for enclosures.

12 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
12
votes
0answers
415 views

Why would installing Windows 9x on a Sager NP8200 or Wedge 466/DX2 laptop brick the system?

In the setup.txt file on the Windows 95 and 98 CDs (located in the \WIN95 [Windows 95] / \win98 [Windows 98] folder), which contains important information on setting up Windows and solving or working ...
9
votes
0answers
232 views

Killer poke on the Ninendo DS via POWCNT1 register

From GBATEK, writes to a certain I/O port for power management may damage hardware: 4000304h - NDS9 - POWCNT1 - Graphics Power Control Register (R/W) 0 Enable Flag for both LCDs (0=Disable) (...
7
votes
0answers
141 views

Need help checking an ADC0808 / ADC0809 chip in a arcade shooting game

Main Question: How can I check a ADC0808 chip to determine if it needs to be replaced or if my issue is something else? Any advice you can offer is SO appreciated! ADDITIONAL INFO When the arcade is ...
5
votes
0answers
223 views

Were vertical monitor arcade games programmed differently from those with horizontal monitors?

Many classic arcade games like Pac Man (Namco 1980), Assault (Namco 1988), Mercs (Capcom 1990), etc, use a monitor oriented vertically. I assume that they used the same physical hardware, with the ...
5
votes
0answers
96 views

IBM terminal schematics

I'm searching for the electronics schematics for IBM terminals 3477 and 3486. I've already googled for it without success. I've to mend this hw and the power side seems ok but doesn't function, so I ...
4
votes
0answers
150 views

Why did Gran Trak 10 cost so much?

In 1974, Atari released a driving game called Gran Trak 10. The development prototypes had used real car steering wheels and pedals, but it was realized these were too expensive, so they were changed ...
4
votes
0answers
84 views

Backlight inverter failure on TI Travelmate

I picked up a TI Travelmate 4000E for free and it worked perfectly using my AC adapter(genuine TI one from another 4000E). The backlight fires up full brightness for about a second, then dies. ...
4
votes
0answers
297 views

Cost of Apple II switching power supply

Apple went to the trouble of designing a switching power supply at a time when they were still quite new and not widely used for consumer electronics, perhaps because Steve Jobs liked the aesthetics ...
2
votes
0answers
142 views

Help debugging a circuit/code for Z80 and TMS9918ANL

I am working on designing a Z80 computer that utilized the TMS9918ANL for graphics. I am currently just trying to make sure the TMS9918ANL is working, so I hooked up the control pins the bus (...
2
votes
0answers
291 views

What was the cost of the PS2 chip in the last PS3 to have it?

The PlayStation 2 provided backward compatibility with the PS1 by essentially incorporating an entire PS1 on a separate chip. It kept this arrangement permanently. The PS3 started off providing ...
2
votes
0answers
113 views

How to reset/recover password on Ascend/Lucent “SuperPipe 155” ISDN router

I am trying to set up a second-hand 1990s era Ascend/Lucent "SuperPipe 155" ISDN router for use with some of my 90s era computers, but I don't know the router's password and the instructions I found ...
1
vote
0answers
127 views

Frozen horizontal width coil in old CRT monitor

I have an old Apple IIe CRT monitor which could use a small horizontal width adjustment. Unfortunately, as I try to rotate the hex key in the coil with a CRT adjustment tool, it doesn't want to move. ...